Construction Plans
Cup Holder
The flat face of the cup holder was designed in Solidworks (a CAD program) and cut using a laser cutter. The size was *INSERT SIZE*. Wooden blocks were screwed into predrilled hols in ordr to create supports. The cup holder holds average sized styrofoam cups.
Materials
- Acrylic Sheet
- Wooden Blocks
- Screws
- Cups
Downloads
Meter
The body of the meter was designed in Solidworks (a CAD program) and cut using a laser cutter. The circut is made up of three LEDs soldered in series, six resistors, and a battery. The soldereing is done on the back. Two wires are left sticking out at the bottom of the meter. The battery is held onto the body with tape.
Materials
- Acrylic Sheet
- Battery
- LEDs
- Resistors
- Wires
Downloads