[Date Prev][Date Next]
RE: AVTS 4.0.4 - Record/Playback Feature
I am back to
trying the Record/Playback Feature. I have made up several different
scripts with 6 ballots. The first script runs all 6 ballots only 1 time
through, and this works fine. I have tried 2 other scripts of 6 ballots, 1
with a repeat of 15, and another with a repeat of 90. Both have failed,
the 15 repeat stops after the 3rd ballot, and the 90 repeat stops at the summary
page of the 2nd ballot.
As you can
see from the thread below, I did the 1 ballot test with a repeat of 16 and that
worked fine. It seems to be a combination of number of ballots &
number of loops. However, it does not break at any consistent
If I were
able to create 1 script, and then able to change the number of loops, without
having to record the script again, I might be able to narrow it down a bit, but
either way there is a problem of some kind.
My educated guess
is that it is a fixed buffer. It will work right up to 6, any
repeat. Would that be sufficient for now?
I did a 1
ballot test with a repeat of 16. This works fine. I will keep
continuing to increase the number of ballots until I can get it to break
same result, or does it fail at different points? If you limit your
test to say 6 or 7 ballots, does it then work
have tried it 4 times, all with the same result.
soon as I get my laptop to be able to recognize the PCMCIA card, I will
send it to you.
then send me both scripts if it doesn't work the second
I have created
a script for voting 8 different ballots, each ballot contains 5
pages, and I have set it up to repeat 64 times. However, when
the script gets to the 7th ballot, it skips voting on the the 3rd
page, and then when it gets to the final Summary Page it just stays
there until you press the F3 key to stop the
recorded the script, I printed out a report to make sure that I had
voted every ballot correctly, and the report was
suggestions??? This is the script that we will need to run for
the Wyle volume test.