HyperTerminal and Digi

I found while debugging Chatham County, that HyperTerminal did not switch between comm ports on the digi board to access, and set the modem registry. In HyperTerminal I would set which comm port I wished to access, but it would always access the first port. So if you don't watch your modems lights to see which modem is being accessed, then you could be setting the same modem over and over again. I used the first port to set all my modems to the proper registry settings, and so far everything seems to be working fine. I am having Chatham run though multiple uploads to GEMS to make sure that everything is working as it should.