Linux version 2.2.10 (ssaewong@word.art.cmu.edu) (gcc version egcs-2.91.66 19990314/Linux (egcs-1.1.2 release)) #21 SMP Fri Jul 28 13:01:41 EDT 2000
mapped APIC to ffffe000 (00263000)
mapped IOAPIC to ffffd000 (00264000)
Detected 299946860 Hz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 299.01 BogoMIPS
Memory: 127948k/131072k available (1072k kernel code, 420k reserved, 1568k data, 64k init)
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.35 (19990512) Richard Gooch (rgooch@atnf.csiro.au)
per-CPU timeslice cutoff: 100.31 usecs.
CPU0: Intel Pentium II (Klamath) stepping 03
SMP motherboard not detected. Using dummy APIC emulation.
PCI: PCI BIOS revision 2.10 entry at 0xfd9cc
PCI: Using configuration type 1
PCI: Probing PCI hardware
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0 for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
Starting kswapd v 1.5 
Detected PS/2 Mouse Port.
Serial driver version 4.27 with no serial options enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
pty: 256 Unix98 ptys configured
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0xfc90-0xfc97, BIOS settings: hda:DMA, hdb:DMA
    ide1: BM-DMA at 0xfc98-0xfc9f, BIOS settings: hdc:DMA, hdd:DMA
hda: Maxtor 91360U4, ATA DISK drive
hdb: Maxtor 90648D3, ATA DISK drive
hdc: ST36450A, ATA DISK drive
hdd: TOSHIBA CD-ROM XM-6102B, ATAPI CDROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: Maxtor 91360U4, 12982MB w/2048kB Cache, CHS=1655/255/63, UDMA
hdb: Maxtor 90648D3, 6179MB w/512kB Cache, CHS=787/255/63, UDMA
hdc: ST36450A, 6149MB w/448kB Cache, CHS=13328/15/63, DMA
hdd: ATAPI 24X CD-ROM drive, 256kB Cache
Uniform CDROM driver Revision: 2.55
Floppy drive(s): fd0 is 1.44M
FDC 0 is a National Semiconductor PC87306
scsi : 0 hosts.
scsi : detected total.
3c59x.c:v0.99H 11/17/98 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drivers/vortex.html
eth0: 3Com 3c905 Boomerang 100baseTx at 0xfcc0,  00:60:97:1d:84:85, IRQ 11
  8K word-wide RAM 3:5 Rx:Tx split, autoselect/MII interface.
  MII transceiver found at address 24, status 782d.
  Enabling bus-master transmits and whole-frame receives.
Partition check:
 hda: hda1 hda2 hda3 < hda5 hda6 hda7 >
 hdb: hdb1
 hdc: [PTBL] [784/255/63] hdc1 hdc2 < hdc5 hdc6 hdc7 > hdc3
VFS: Mounted root (ext2 filesystem) readonly.
rk_cpu_calibration: Calibrating cpu ..... 299945540 cycles per second.
Freeing unused kernel memory: 64k freed
Adding Swap: 265036k swap-space (priority -1)
gdb_hook_interrupt: set_debug_traps()
gdb_hook_interrupt: breakpoint()
int3: 0000
CPU:    0
EIP:    0010:[<c011024e>]
EFLAGS: 00000202
eax: 00000021   ebx: c0226fc0   ecx: 00000005   edx: c30b2000
esi: c0004da0   edi: 00000076   ebp: 00000000   esp: c3db5ecc
ds: 0018   es: 0018   ss: 0018
Process gdbstub (pid: 1002, process nr: 40, stackpage=c3db5000)
Stack: c01f76c0 0000547f c5b27000 c01ac592 c0004da0 c5b27000 00000000 00000076 
       c5b27000 00000206 c024ac40 c3e9e620 00000002 c3db5f4c c0004da0 03010305 
       00000000 c022c000 c022c000 c0113977 c3db5f54 c022c000 c3db4000 000002b3 
Call Trace: [<c01f76c0>] [<c01ac592>] [<c0113977>] [<c01a18b8>] [<c0131439>] [<c01296ef>] [<c0109150>] 
Code: c3 90 a1 f0 e0 ff ff c7 05 b0 e0 ff ff 00 00 00 00 c3 53 31 
clockwise v.2.0 for IDE is running 
cw_init: 1024 dynamic partititons
init_module: Clockwise loaded as module.
cw_open: mode 00000000
cw_open: mode 00000000
cw_open: mode 00000000
cw_ioctl (CW_GEOMETRY) is called 
cw_open: mode 00000000
cw_ioctl (CW_ADDDISK) is called 
cw_ioctl (CW_GO) is called 
cw_consistent: No disks?
cw_open: mode 00000000
cw_ioctl (CW_ADDDISK) is called 
cw_ioctl (CW_GO) is called 
cw_consistent: No disks?
cw_open: mode 00000000
cw_ioctl (CW_ADDDISK) is called 
cw_ioctl (CW_GO) is called 
cw_consistent: No disks?
cleanup_module: Freeing dtypes
cleanup_module: Freeing inodes
cleanup_module: done
clockwise v.2.0 for IDE is running 
cw_init: 1024 dynamic partititons
init_module: Clockwise loaded as module.
cw_open: mode 00000000
cw_ioctl (CW_GEOMETRY) is called 
cw_open: mode 00000000
cw_ioctl (CW_ADDDISK) is called 
cw_ioctl (CW_GO) is called 
cw_consistent: No disks?
cw_open: mode 00000000
cw_open: mode 00000000
cw_ioctl (CW_ADDDISK) is called 
cw_ioctl (CW_GO) is called 
cw_consistent: No disks?
