|
As described it sounds like a bug, but it
is pretty strange that the three examples you cite are not consistent –
two creates and one clear. Go ahead and
post it. Bugzilla
is limping along enough that you can post new bugs. It is just the history that is shot. Ravina, if you can try to reproduce this, it
would be appreciated. Ken -----Original Message----- I have found the following when
using the new "Diebold Voter Card Encoder" with 1.1.3 during training
in Columbus, GA. From the encoder I created the
following "voter cards"; ("M") magnified ballot,
("VM") visual magnified, and ("VH") visual hidden The units were set in election mode
and the cards were voted then re-inserted to clear and program again. When you re-insert the
("M") voter card the display on the encoder reads M
"create" When you re-insert the
("VM") voter card the display on the encoder reads VM
"create" When you re-insert the
("VH") voter card the display on the encoder reads VH
"clear" Correct me if I am wrong, but when
you re-insert the card for re-programming it should simply say
"clear", then you select "yes", then it should say
"create", it should not have the codes,(M, VM, VH) there at
all. The way it is now, you can NOT clear the voter card, if you have
selected one of the codes. You can create a new card as long as you are
going to use one of the codes, i.e., "M", "VM", "VH". This was confusing for my students,
in that once they created a card with one of the codes, they could not re-use
that card as a regular voter card, meaning not able to access a regular ballot. Pleas let me know if I need to post
this to the bugtrack once it is back in action. Rodney D. Turner 214-642-6289 |