Newsgroups: alt.comp.hardware.homebuilt,comp.robotics,sci.electronics
From: Chris@ruatha.demon.co.uk (Chris G Abbott)
Path: cantaloupe.srv.cs.cmu.edu!fs7.ece.cmu.edu!hudson.lm.com!news.pop.psu.edu!news.cac.psu.edu!howland.reston.ans.net!pipex!demon!ruatha.demon.co.uk!Chris
Subject: Re: Gerber Files (PCB Artworks)
References: <786917433snz@ruatha.demon.co.uk>
Organization: Myorganisation
Reply-To: Chris@ruatha.demon.co.uk
X-Newsreader: Demon Internet Simple News v1.29
Lines: 38
X-Posting-Host: ruatha.demon.co.uk
Date: Sat, 10 Dec 1994 10:56:40 +0000
Message-ID: <787057000snz@ruatha.demon.co.uk>
Sender: usenet@demon.co.uk
Xref: glinda.oz.cs.cmu.edu comp.robotics:16168 sci.electronics:111210

OK, thanks to the following for there e-mail:-

      Josef Dalcolmo
      Mike Loving
      Stan Eker
      P.Bennett
      Michael Burr
      Tom Kellett


There are some real programs (i.e. cost money), one of which is :-

   Gerber Toolkit - Available from 1-800-767-6728 (Personal Computing Tools)
                    $249.


But there is a shareware (freeware) one :-

   GraphiCode GC-PREVUE.

   It is available at many sites, under some of the following guises :-

   gcpvu.zip , gcprevue.zip , prevue.zip

   I found it at   sundae.triumf.ca::/pub/peter/prevue.zip

   From the e-mail received, it does take a little setting up, and printing
   the manual is a good idea. From the basic look I have taken so far, it
   comes with a tutorial.


Thanks again folks.

-- 
God Bless

Chris Abbott
============================================================================
