Newsgroups: comp.robotics
Path: brunix!sgiblab!swrinde!pipex!uknet!EU.net!uunet!newsflash.concordia.ca!canopus.cc.umanitoba.ca!bison!draco!baden
From: baden@draco.bison.mb.ca (Baden de Bari)
Subject: [*] Multiple piece staming
Organization: The Draco Unix System
Date: Mon, 23 May 1994 02:55:44 GMT
Message-ID: <1994May23.025544.4038@draco.bison.mb.ca>
Lines: 15


	I am working on a project where several different sizes of pieces
will be cut from one sheet.  I would like information on how to stamp these
pieces / I.D. them after they've been rolled off the automated cutter.

----------------------------------------------------------------------
Words Wise and Otherwise...              /\
Your son at five is your master, at ten  ||      Baden de Bari
 your slave, at fifteen your double and  || baden@draco.bison.mb.ca
 after that, your friend or your foe,    || baden@sys6626.bison.mb.ca
 depending on his bringing up.           ||
            -HASDI IBN SHAPRUT           \/
----------------------------------------------------------------------


