Newsgroups: comp.robotics
Path: brunix!sgiblab!swrinde!cs.utexas.edu!uunet!newsflash.concordia.ca!nstn.ns.ca!newton.ccs.tuns.ca!vandomr
From: vandomr@newton.ccs.tuns.ca (Ronnie VanDomemelen)
Subject: miniboard connection
Message-ID: <1994Jan11.193705.19675@newton.ccs.tuns.ca>
Date: Tue, 11 Jan 1994 19:37:05 GMT
Organization: tuns.ca
Lines: 21

Hello once again.  I have asked assistance on this problem before
but please bear with me.  A while ago I couldn't get my PC/6811
connection to work.  I was told by netters to switch my transmit
and receive.  I did and the cord woked fine.  Later I took the cord
apart to use it for something else.  When I rturned it to its original
use, it wouldn't work.  I've checked to make sure connections are
correct and I've tried switching trans/rec with no luck.

In original mode (as shown in Fred Martins guide) the red LED goes dim
and turns off as it should when rest is pressed; but no program can be
sent.  DLM says no connection was made.  When I switch trans/rec, the
red LED stays dim and again nothing can be sent.

Please help or suggest possible solutions.
Thanks yet again; Ronnie(vandomr@newton.tuns.ccs.ca)
  
-- 

------------------------------------------------------  
||||||||||||||||||||||||||||||||||||||||||||||||||||||  
 Ronnie Van Dommelen        |   "Engage."
