Newsgroups: comp.robotics
Path: brunix!uunet!vuse.vanderbilt.edu!pacman
From: pacman@vuse.vanderbilt.edu (Robert Todd Pack)
Subject: Pneumatic Valves
Message-ID: <BwwL2r.1xG@vuse.vanderbilt.edu>
Originator: pacman@irl1
Sender: news@vuse.vanderbilt.edu
Nntp-Posting-Host: irl1
Organization: Vanderbilt University School of Engineering, Nashville, TN, USA
Date: Thu, 29 Oct 1992 21:59:13 GMT
Lines: 26


Hello Netlanders,
   I have looked high and low for some small pneumatic
servo valves. I just can't seem to find anything like
what I want. Here are my basic specifications:
        (1) Pneumatic Servo Valve that can handle around 100 PSI.
        (2) It must be about to vary output pressure from 0 to max.
        (3) The valve should be relatively small and light.

Requirement (3) is the one that is stopping me. I have some servo
valves, but they are the size and weight of a good textbook. I want
to use these pneumatic values in a mobile robot, so I need some
smaller and lighter valves.

   Have any of you seen something like this? Used something like 
this? Any information would be greatly appreciated. Especially
the names and addresses of Companies!

                                        Sincerely,
                                        Robert Todd Pack
                                        pacman@vuse.vanderbilt
-- 
/--------------------------------------------------------------------------\
/ Robert Todd Pack		|	"I think, therfore I'm spam."	   \
/ pacman@vuse.vanderbilt.edu	|    Windows/NT -> Multics for the 90's    \
/--------------------------------------------------------------------------\
