>>> 'sink10' problem from richard -- Tue Sep 19 11:50:50 1989 <<<

There is a leak in the hose of the DI water sprayer.

>>> 'sink10' problem from bob -- Tue Sep 19 14:53:25 1989 <<<

The deck hose on sink10 has been changed to a black retractile
hose. Richard Hsu has been shown the quick disconnect feature
so the next time a deck hose leaks he can shut off any water 
leak.

>>> 'sink10' problem from spence -- Tue Oct 24 10:59:53 1989 <<<

the nozzle from the N2 gun on sink 10 has been removed. I would like to know
Why?
By whom?
Whether a replacement is necessary
and if so, where can I get one?
Thanking you for your support
Chris

>>> 'sink10' problem from spence -- Wed Nov 15 12:35:00 1989 <<<

the temperature controller that controls the temp of the silylation
HOT-Plate is acting strangely. i.e. it now indicates a temperature
5-10 C above the set point when it has 'stabilized'. Could Phil
look into this? thanks
Chris

>>> 'sink10' problem from phillip -- Thu Nov 16 07:39:58 1989 <<<

Chris, let me know next time you use your 'sily' device.
I will trim the temp. coincident with your use (today).
pg

>>> 'sink10' problem from partlo -- Tue Nov 28 13:32:14 1989 <<<

A hose supplying house air to sink 10 popped off its barb.
The hose went to SV-2.  I shut off the house air at its supply
valve.

>>> 'sink10' problem from bob -- Wed Nov 29 06:59:31 1989 <<<

The hose that broke on sink10 has been replaced and the air turned back
on. sink10 is up however the temperature controller still needs calibration.
Spence will contact Phillip when both are available.

>>> 'sink10' problem from spence -- Wed Nov 29 18:01:42 1989 <<<

I take back my comments of earlier today about he silylation hotplate.
It is still running higher than the set point by about 5-8 C.
(set point = 130C). Can Phill have a look at it please?
Chris
.,

>>> 'sink10' problem from phillip -- Thu Nov 30 08:42:34 1989 <<<

Instated extender card to calibrate PID controller.
Will work with Chris when he arrives to rectify problem.

>>> 'sink10' problem from bob -- Wed Feb 28 16:03:39 1990 <<<

sink10 is down due to a power problem in the R-1. It has been
valved off of the vacuum drains.

>>> 'sink10' problem from phillip -- Fri Mar  2 08:32:35 1990 <<<

This sink was subject to a power problem. That has been cleared.
Sink10 is up.,
