Newsgroups: comp.robotics
Path: cantaloupe.srv.cs.cmu.edu!europa.chnt.gtegsc.com!news.mathworks.com!hookup!news.moneng.mei.com!uwm.edu!fnnews.fnal.gov!gw1.att.com!gw2.att.com!nntpa!not-for-mail
From: wrb@cbitn26.cb.att.com ()
Subject: Re: What the heck are fle
Message-ID: <D78v26.I17@nntpa.cb.att.com>
Sender: news@nntpa.cb.att.com (Netnews Administration)
Nntp-Posting-Host: cbitn26.cb.att.com
Organization: AT&T Columbus
References: <3m6tba$t4h@sol.sun.csd.unb.ca> <9504150426012905@bordertown.com>
Date: Tue, 18 Apr 1995 18:51:40 GMT
Lines: 15

In article <9504150426012905@bordertown.com>,
Gary Schaum <gary.schaum@bordertown.com> wrote:
>        I am also interested in small home shop CNC ever since the
>        series of articles came out in Nuts and Volts.  My subscription
>        expired in the middle of the series and I missed the one that
>        had the controller information in it.
>

Check out the 3 axis controller on ftp.ee.ualberta.ca under
/pub/cookbook/comp/parallel/3axis.tar.Z (a compressed tarfile).  It is a controller
designed to control 3 unipolar steppers at up to 35V and 1.25A.  It is made especially
to work with DANCAD3d, but is flexible enough to use with other stuff too.
-- 
Wallace (Wally) Blackburn		.sig under construction
wrb@cbitn1.cb.att.com
