Newsgroups: comp.robotics
Path: brunix!uunet!europa.eng.gtefsd.com!howland.reston.ans.net!noc.near.net!gateway-gw!newshost!wpns
From: wpns@newshost.pictel.com (Willie Smith)
Subject: Re: How to Make Axels/Bearings/Belts/Bushings/Gears/Pulleys?
Message-ID: <1993Jul16.170350.1543@newshost.pictel.com>
Keywords: axel, bearing, belt, bushing, gear, pulley
Organization: PictureTel Corporation
References: <22688lINN85k@uwm.edu>
Date: Fri, 16 Jul 1993 17:03:50 GMT
Lines: 13

In article <22688lINN85k@uwm.edu> rick@ee.uwm.edu (Rick Miller) writes:
>I've been stripping small, broken electronics for motors, gears, pulleys

>Does anyone have any hints on how to make good/quick/cheap mechanical
>components like these for small, high-efficiency robotics?

I 'make' most of my hard-to-find parts by picking up the phone and
calling McMaster-Carr, Small Parts Inc, Berg, or Stock Drive Products.
Very little capital investment is needed to 'produce' all kinds of
stuff!
-- 
Willie Smith	wpns@pictel.com		N1JBJ@amsat.org
Usenet is a way of being annoyed by people you otherwise never would have met
