Newsgroups: sci.electronics,comp.robotics,rec.models.rc
Path: cantaloupe.srv.cs.cmu.edu!rochester!udel!gatech!news.sprintlink.net!noc.netcom.net!netcomsv!uu3news.netcom.com!ddiq.com!carl
From: carl@ddiq.com (Carl Fickling)
Subject: Re: Servo Reversing circuit
Organization: Decision Servcom Inc
Date: Fri, 19 May 1995 16:53:04 GMT
Message-ID: <D8u48H.LqM@ddiq.com>
References: <DKN.95May15122459@cimar.me.ufl.edu> <NAHSHON.95May16144337@rs3bt-01.haifa.ibm.com> <3pg36s$j4h@hpbab.wv> <tker1.24.2FBBDB5D@MFS01.cc.monash.edu.au>
Sender: news@ddiq.com (The Netnews Big Cheese)
Lines: 15
Xref: glinda.oz.cs.cmu.edu sci.electronics:133087 comp.robotics:20904

Terry Kerr <tker1@MFS01.cc.monash.edu.au> wrote:
-snip-
>
>If the transmitter doesn't have servo reversing capabilities, then it will 
>be a very simple transmitter.  In this case you can just open up the back of 
>the transmitter, and find the POT of the channel that you wish to reverse.  
>Just simple swap the two end wires around(there are 3 tags on the POT, swap 
>the wires soldered to the first and third tags around).  Now...how hard was 
>that!
>
I think you missed the point. It was desired to have two servo's on one port
connect with a Y adaptor and have one servo reversed. Please try to edit
out some of the long repeats, Thanks.

Carl, in Fremont, CA.  Corsair's are more fun.
