Newsgroups: comp.robotics
Path: cantaloupe.srv.cs.cmu.edu!das-news2.harvard.edu!news2.near.net!satisfied.elf.com!news.mathworks.com!udel!gatech!darwin.sura.net!news.Vanderbilt.Edu!barilejb
From: barilejb@vuse.vanderbilt.edu (Jason Blue Barile)
Subject: Re: Floating Point Calculations on the Miniboard
Message-ID: <1995Feb1.202913.20845@news.vanderbilt.edu>
Keywords: Miniboard
Sender: news@news.vanderbilt.edu
Nntp-Posting-Host: necs.vuse.vanderbilt.edu
Organization: Vanderbilt University School of Engineering, Nashville, TN, USA
References: <3glloc$jko@mercury.dur.ac.uk>
Date: Wed, 1 Feb 1995 20:29:13 GMT
Lines: 20

In article <3glloc$jko@mercury.dur.ac.uk> S.D.Robinson@durham.ac.uk writes:
>Hello,
>Is there a C compiler for the miniboard that will allow floating point calculations, and which will fit into the memory space provided on the board?
>I possess only the ICC11 freeware version which does not support this. Does the full release have this feature, and will it fit onto the board? (if so where can I buy it)
>Has anybody made custum code that uses integers to perform floating point calculations? Did it fit?
>
>Thanks in advance
>Steve
>
>S.D.Robinson@durham.ac.uk 

There is an excellent IEEE library on bode.ee.ualberta.ca for the HC11.  It is
entirely assembly-based though, so using ICC11 might not be the best idea.



-- 
- Jason Barile   email: barilejb@vuse.vanderbilt.edu
                  html: http://www.vuse.vanderbilt.edu/~barilejb/barilejb.htm
-----------------------------------------------------------------------------
