Newsgroups: comp.robotics
Path: cantaloupe.srv.cs.cmu.edu!das-news2.harvard.edu!news2.near.net!news.mathworks.com!hookup!news.sprintlink.net!redstone.interpath.net!hilbert.dnai.com!nic.scruz.net!earth.armory.com!rstevew
From: rstevew@armory.com (Richard Steven Walz)
Subject: Re: help with 286 I/O pinouts
Organization: The Armory
Date: Sat, 3 Dec 1994 15:19:43 GMT
Message-ID: <D08qKw.HJw@armory.com>
References: <3bgod1$f7r@grivel.une.edu.au>
Sender: news@armory.com (Usenet News)
Nntp-Posting-Host: deepthought.armory.com
Lines: 22

In article <3bgod1$f7r@grivel.une.edu.au>,
Douglas Belton <dbelton1@metz.une.edu.au> wrote:
>Please help,
>	I hope I'm writing to the right newsgroup.
>
>	I'm just getting into computer control (not necessarily robotics)
>but I have hit a big obstacle before I can start -- I don't know the
>pin diagram for the I/O slots in my computer.
>
>	I have a Hewlett Packard Vectra ES.  I think it has a 286 processor so
>I guess that the I/O slots are the same for any other 286.
>
>	If anyone can help me in any way, could you please email me
>at the above address?
>
>	Thanks,
>		Doug.
---------------------------------------
No, but I can tell you to get it from ftp.armory.com /pub/user/rstevew
and the filename is "isabus.tut".
-Steve Walz   rstevew@armory.com

