Newsgroups: comp.robotics
Path: brunix!doorknob!kwh
From: kwh@cs.brown.edu (Kwun Han)
Subject: Re: docs for 6.270
In-Reply-To: dulimart@cps.msu.edu's message of 15 Oct 1993 18:44:52 GMT
Message-ID: <KWH.93Oct15152453@tahoe.cs.brown.edu>
Sender: news@cs.brown.edu
Organization: Dept. of Computer Science, Brown University
References: <KWH.93Oct15132830@tahoe.cs.brown.edu>
	<DULIMART.93Oct15144453@pacific.cps.msu.edu>
Date: Fri, 15 Oct 1993 20:24:53 GMT
Lines: 30

In article <DULIMART.93Oct15144453@pacific.cps.msu.edu> dulimart@cps.msu.edu (Hans S. Dulimarta) writes:
      Hi 6.270 boarders,

	      I am current setting up a 6.270 board. However, I am facing
      some problems. When I power on the board, the yellow SER XMIT LED and
      LED17 and LED18 on the expansion glows continuously. The hardware
      manual says refer to the "debug section under startup".  However, I
      can't find this section. I wonder if anyone know where this section is
      or if someone know what the problem is?

      Any help will be appreciated.

      Kwun

   I experienced the same situation too.  The SER XMIT LED on the
   microprocessor board and LEDs 17 and 18 are on continuously, and I
   couldn't find the "debug section under startup".  Also, there is no
   instruction on how to connect the LCD to the expansion board.


   Hans.

Oh yes.. at least I am not alone, have you tried plugging in the
serial line and does the greed LED come on?? On my board, the green
LED blinks a few time and then goes dim after it is properly
inserted..

I am really confused.. Help.. 

Kwun
