Newsgroups: comp.robotics.research
Path: cantaloupe.srv.cs.cmu.edu!das-news2.harvard.edu!news2.near.net!news.mathworks.com!gatech!howland.reston.ans.net!spool.mu.edu!umn.edu!news
From: kachina@gate.net (Les Archuleta)
Subject: 5-axis algorithms
Message-ID: <D8qz2s.D77@news.cis.umn.edu>
Followup-To: poster
Sender: news@news.cis.umn.edu (Usenet News Administration)
Nntp-Posting-Host: tera.cs.umn.edu
Organization: none
Date: Thu, 18 May 1995 00:09:22 GMT
Approved: hougen@cs.umn.edu, crr@ireq-robot.hydro.qc.ca
Lines: 22

Congratulations on the new group.  We are living in an exciting time.  I
hope it reflects in this new group.

I'm interested in literature or information about algorithms for
generating a toolpath for a 5-axis "scuplting" milling machine.  I have
written the complete software for three axis machines.  I have a few ideas
on how to approach the 5-axis.  

You may post a response, but I prefer E-mail.

Thank You

Les Archuleta

[Note that followups have been set to poster, as per the poster's request
for email.  We *will* accept responses for posting if you override this
setting and respond to the group or send email to our submission address,
crr@ireq-robot.hydro.qc.ca  - DH]

     *********************** (moderated) ***************************
            Submissions:             Meta-discussions/information:
     crr@ireq-robot.hydro.qc.ca   crr-request@ireq-robot.hydro.qc.ca
